| Engine |
Kubota V 2203 M, 2.2 liter,
4 cylinder, 4 stroke, turbocharged indirect injection diesel,
water cooled, 49.5 HP* @ 2800 rpm. Mounted on sound and
vibration absorbing blocks. |
| Electrical |
12 V 90 A
alternator, 88 Ah high capacity cold-start battery. Turn off
using ignition key. Central electronics display panel for ground
speed, water temperature, fuel, front/rear PTO rpm, engine rpm,
and run hours. |
| Transmission |
Continuously
variable two-speed hydrostatic drive with adjusting pump and
motor which can be changed under load. |
| Speeds |
Slow range; 0 to 7.5 mph.
Fast range; 0 to 18.6 mph. The whole speed range can be selected
using the multi-function drive lever for both forward and
reverse drive without any interruption of the transmitted power. |
| Power take-off |
Single dry clutch
plate for independent PTO shaft
operation. Front and rear PTO shafts can be engaged under load.
Standard 1-3/8",
six splines. Rotation speeds: front 591 rpm, rear 610 rpm. Clockwise
rotation viewed from end of PTO shaft. |
| Axle drive |
4-wheel drive with
differentials on both axles, rear axle always engaged, front
axle can be hydraulically engaged. Front and rear differential
locks electro-hydraulically pre-selectable, status
indicator light. 100% mechanical locking. |
| Steering |
Hydrostatic 4-wheel
steering based on a 'load sensing' system. Front wheel steering
pre-selectable via push button. The automatic sensing and
synchronization of the wheel positions using inductive sensors
makes it possible to change the steering mode at any time, even
while in motion. 9.5-foot turning radius. |
| Tires |
Low pressure Terra tires,
31x15.50-15/6 PR. |
| Brakes |
Foot brakes: hydraulic
servo brakes operating on all four wheels. Hydrostatic driving
brake. Handbrake and independent wheel brakes: mechanical servo-assisted
brakes operating on rear wheels. |
| Driver's cab |
Vibration damped driver's
cab. OECD approved roll guard (ROPS). Curved front windshield. Comfort seat. |
| Hydraulics |
2538 psi. Flow rate
5.9 gal/min @ 2800 rpm. 2.1 gallon oil reservoir for auxiliary
hydraulic cylinders. |
| Front hydraulic linkage |
3-point cat. I. Lifting
power: 2698 lbs. Controlled using seat valves with the functions
raise, carry, lower, float position, weight transfer. All functions selectable using
the multi-function drive lever. "Weight transfer"
function, infinitely adjustable. Adjustable sink throttle.
External lift/lower controls. Quick action couplings on the
lower link (pick-up hooks). |
| Auxiliary hydraulics |
DWAS-, two
connectors at the front and rear for double-action cylinders
with float position. |
| Fuel tank |
10.8 gallons |
| Weights |
Weight |
3638 |
lbs |
| Max. permissible front axle weight |
3527 |
lbs |
| Max. permissible rear axle weight |
3527 |
lbs |
| Max. permissible total weight |
6173 |
lbs |
| Trailer coupling load max. |
661 |
lbs |
| Trailer weight (with brakes)
max. |
6614 |
lbs |
| Trailer weight (without brakes)
max. |
1323 |
lbs |
| Dimensions |
Length w/o rear hydraulic
linkage |
109.4 |
in |
| Length with rear hydraulic
linkage |
129.3 |
in |
| Width |
70.0 |
in |
| Height |
76.4 |
in |
